fret slot depth
Solved: Blind Fret Slots - Help Needed - Autodesk Community
fret slot depth
website fret slot depth It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is fret slot width You generally only use a table saw to cut fret slots when the fretboard is still flat Then after radiusing you just use a hand fretsaw with a
fret slot depth Later sanding? With frets installed? no- I slot, then glue the FB on, then sand level etc, then fret IF you are about to take on a refret job of a fretted instrument, you should be checking the depth of the fret slots Still a good idea to check the fret slot Fret slots should be clean and deep enough to receive the tang with room to spare On bound necks, make sure you get the binding glue out of the corners You'll
Unable to load receipt Availability
