Perspex Fret Slotting Saw Depth Guide

website fret slot depth Fretwire has a toothed piece called the tang which will stick into a slot in the fretboard The tang is typically in width, so ideally you fret slot depth IF you are about to take on a refret job of a fretted instrument, you should be checking the depth of the fret slots Still a good idea to check the fret slot

fret slot depth Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough Dan Erlewine developed this  GUITAR FRET SAW WITH SLOT DEPTH GAUGE  I use an Irwin dovetail pull saw with a bit of wood super glued to the saw to stop the cut at the correct depth The saw follows the radius of

Share

Share

Link

Turn off sharing Copy link

See all details